How to Use These Stencils
3 part vinyl stencils for Glitter Tattoos
Apply Stencil 1. Start with CLEAN, dry skin! Wash skin with rubbing alcohol and choose a hair-free location for best results. Let the skin dry thoroughly. 2. Carefully remove the white backing layer of the stencil to reveal the adhesive, leaving the clear layer in place. 3. Apply sticky adhesive side of the stencil to clean skin. Rub firmly over the entire stencil. Make sure the stencil is fully and completely adhered to the skin. |
|
Starting from a corner, carefully remove the clear transfer tape from the top layer of the stencil. Using your fingernail, pull one of the top edges and slowly roll it down and away from the vinyl stencil. If a piece of the stencil sticks to the transfer tape, just lay it back on the skin, press it down again and then continue removing the top layer. |
|
Apply Glue Allow the adhesive to dry briefly to prevent smears. You're ready to apply the glitter! |
|
Apply glitter! |
|
Gently rub the glitter onto the glue/skin to make sure it's fully adhering to the adhesive. |
|
Remove the stencil by peeling up an edge and rolling the stencil back on itself. A toothpick can be used to help pull off any stubborn pieces. Brush off excess glitter.
|
|
Sparkly glitter tattoos will last up to a week!
Remove with, isopropyl myristate, make-up remover, or scrub off after a soak in the bath. |